Page 8
Work Light II
Installation & Users Manual
C-Clamp Installation
The provided c-clamp should be installed as shown in
Figure 2
. Only use the hardware supplied with the
c-clamp.
To Install the C-clamp:
1. With luminaire on a flat, sturdy surface, position yoke assembly for easy access as illustrated in
Figure 2
.
2. Place on 1/2-13 hex bolt, in this order, the 1/2-inch lock washer and then the 1/2-inch flat washer.
3. Insert bolt into hole on yoke assembly.
4. Position c-clamp over bolt and thread bolt into c-clamp.
5. Tighten bolt.
Safety Cable Installation
The provided safety cable should be installed in accordance to local and national codes.
NOTE
: The safety cable (supplied with unit)
should be used and may be required by local
and/or national codes when hanging this
luminaire. The mounting structure must be
capable of supporting the weight of the fixture,
lens, cabling, any accessories, etc.
C-Clamp
Worklight II Yoke
1/2-inch (13mm) Mounting Hole
1/2-inch Flat Washer
1/2-inch Lock Washer
1/2-13 Hex Bolt
C-Clamp
Safety Cable Anchor Point
Figure 2: C-Clamp Installation
