7
4.3 CHANGING THE FUSE
This unit incorporates an internal, worldwide voltage operation power supply, and it is prepared to work from 90
to 264 VAC, 50-60Hz.
Make sure that the unit is disconnected from the mains.
In the unit rear panel are placed the mains connector and the fuse holder. The box bellow this mains
connector is called fuse holder. Take out the fuse holder.
After extracting the fuse holder, the fuse will appear, take it out and change for a new one.
Insert the fuse holder into the mains connector again.
Make sure that the fuse is the right one: 2A slow blow type –
T2A.
CAUTION:
Always make sure after changing the fuse, that it is the right one.
4.4 CONNECTING TO THE MAINS
The connection of the MAP processors to the mains takes place by a standard cord included in the box.
Make sure that the unit power switch is at 0 position (turned off).
Insert the female I.E.C. connector of the tripolar cable into the unit power supply male
connector, placed at the rear panel.
Insert the male connector of the tripolar cable into the mains plug.
Turn on the unit power switch. In that moment the LEDs indicators will light, indicating
that the unit is turned on. The STATUS led will lights green when the system boots up
in right conditions. Otherwise in red.
CAUTION:
Make sure that the voltage is on the range and the fuse is the right one.
MATRIX AUDIO PROCESSOR MAP128 /MAP1216