96
DRIVE & DRIVEN GEARS -
REMOVAL & INSTALLATION
1.
Remove the gearbox cover (
2.
Remove the left boot guard (
).
3.
If the tool is available, remove the drive chain
(
) and the primary drive sprocket (
),
and attach holding tool to the output shaft. If the tool is
not available, leave the drive chain in place, and have
an assistant prevent the rear wheel from turning during
the loosening/tightening steps. (
Fig. 32
)
4.
Loosen the drive gear bolt (
A
) or driven gear nut
(
B
) as required. Remove the fastener, and then slide
the gear off the motor output shaft or countershaft.
Removal of the drive gear bolt and driven gear nut
should be done with the Alta Motors special tool.
Use of this tool requires removal of the Skidframe.
(
Fig. 33
)
Fig. 32
Fig. 33
CHAPTER 6
