Alta Motors Redshift MX 2017, Owner'S Service Manual

Page: 102 / 122

102
RETURN TO TABLE OF CONTENTS RETURN TO TABLE OF CONTENTS RETURN TO TABLE OF CONTENTS RETURN TO TABLE OF CONTENTS RETURN TO TABLE OF CONTENTS RETURN TO TABLE OF CONTENTS
COUNTERSHAFT BEARINGS
RIGHT-SIDE BEARING
1. Remove the motor and output shaft assembly
(
SEctioN 13
).
2. Mount the motor/output shaft assembly on a hydraulic
or arbor press using the proper adapters; with the output
shaft facing down, press the countershaft and bearing
from the motor plate. Note: Alternatively, a two-jaw
puller can be used to push the output shaft and bearing
from the motor plate.
3. Assemble a bearing splitter underneath the right-side
countershaft bearing, then mount the shaft and splitter
on the press, and push the shaft through the bearing.
CautioN: BE suRE to suppoRt thE shaFt with oNE
haNd whilE doiNg this – do Not lEt thE shaFt Fall.
4. Clean the mating surfaces of the countershaft to
remove any burrs or raised edges before sliding the new
bearing onto the output shaft. using the proper adapters,
Fig. 41 Fig. 42
press the bearing onto the shaft until it is fully seated
against the shaft’s collar.
CautioN: MakE suRE thE adaptER oNly coNtacts
thE iNNER RacE oF thE bEaRiNg.
( Fig. 41 )
5. Remove the old O-ring from the countershaft.
Lubricate the new O-ring with multi-purpose grease,
and install it onto the splined end of the countershaft.
6. Place the motor and motor plate onto the nest
fixture, and then set the countershaft into position on
the motor plate. Using the proper adapter, press the
shaft and bearing into the motor plate until the
bearing is seated. (
Fig. 42 )
7. If replacing the left-side countershaft bearing, proceed
to the next step. If not, reinstall the motor and output shaft
to the RBH.
CHAPTER 6