GEM80-500 Series Controller
5. Programming
(08/04)
GEM80-500 Technical Manual (T2025En)
Page 5-27
Table
5-11
V-Table
Content
Address Content
Remarks
V0 Not
used
-
V1 Compilation
count,
moving flag.
Low byte contents are incremented after each
successful compilation
V1.8 =1 Moving ( See note 1 )
V2 to
V47
Used by system software
for data table offsets and
lengths
-
V48 to
V51
Reserved for system usage
-
V52
Length of the message
area in bytes
-
V53 to
V57
Reserved for system usage
-
V58 V-table
checksum
-
V59
User program checksum
-
V60 P-table
checksum
-
V61
FIP network subscriber
address (if present)
-
V62
Front Panel Switch setting
This is read once when the controller is powered up.
V63
Always 0
No off-line support
V64
Firmware issue
This is copied from the firmware issue in the format
A_
V65 to
V66
Reserved for System Usage
-
V67 to
V71
Plug-in Module Identifiers
V67 to V71 do not give any indication of the slot
positions of the modules. The first module found is
reported in V67, the second in V68 etc. If less than 5
modules are present, then the unused entries
contain 0.
@0711
1
st
Basic I/O Module (Basic Ribbons 1 and
2)
@0715
2nd Basic I/O Module (Basic Ribbons 3
and
4)
@0710
1
st
Basic/Verification I/O Module
(Basic Ribbon 1 / Verification Ribbon 1)
@0714
2
nd
Basic/Verification I/O Module
(Basic Ribbon 3 / Verification Ribbon 1)
@0628
1
st
Serial Communication Module Ports 1
and
2
@052C
2
nd
Serial Communication Module Ports 3
and
4
@1318
FIP Module
@2720
1
st
GEMCAN I/O Scanner Module
@2724
2
nd
GEMCAN I/O Scanner Module