42
Self-tapping screws (M4×20)
Machine tooth screws (M5×8)
Host controller tray (used in reverse mold installation)
Large and small 3M tapes
Used in tray (reverse mold) installation or installation directly on the dashboard.
Precautions about host controller installation
Check whether the cables provided are long enough. Please install the device in a place where it would not come in contact
with water.
Please do not install this device or wires in a place that hinders driving or the air bag; for example, the console or dashboard.
Please make sure that the host controller is firmly fixed. If not firmed fixed, the host controller may fall off during driving.
Connection of USB storage (sold separated)
Connect USB storage
This device has one USB port in the front and two USB ports in the rear. You can connect a USB device to any port or connect
two or three USB devices at the same time. However, you cannot connect two or more rechargeable devices at the same time.
When connected to the rear USB port, the accompanied USB extension cable may be used.
Note:
When removing the USB storage, please pull it out straightly.
If no sound is output when a USB storage is connected or the USB storage is not recognized, please
remove the USB storage and connect it again.
Keep the USB cable far from other cables.
Rear USB extension cable
(accompanied)
and/or
USB storage (sold
separately)