13
Note:
The frequency setting of each waveband must not exceed the frequency value of the adjacent
waveband.
When adjusting the parametric equalizer, the frequency response of the speaker connected should be
considered.
When adjusting the parametric equalizer, the preset equalizer that has been adjusted will be invalid.
After adjusting the parametric equalizer, the preset equalizer will become “Custom”.
Adjust the channel balance of the speaker output
Setting item: channel balance
Setting content: L15~0~R15 (initial value: 0)
Adjust the fader of the speaker output
Setting item: fader
Setting content: F15~0~R15 (initial value: 0)
Adjust input source volume
1 Select input source volume adjustment in the sound effect setting mode, and then short press the knob.
2 Turn the knob to select USB audio source, and then short press the knob to confirm.
3 Turn the knob to adjust the volume in the setting range of -60dB~0dB (initial value: 0dB), and press the exit
button to select the source.
4 Repeat step 2 and step 3 to adjust the Bluetooth, high level, and AUX volume.
Note:
For audio sources, the options
available are USB ↔ Bluetooth ↔ High level ↔ AUX
Adjust time correction
Before performing the following steps, refer to “About time correction”.
1 Select “Adjust time correction” in the sound effect setting mode, turn the knob to select the speaker or time
correction unit for adjustment, and then short press the knob.
Left front speaker (F-
L)↔Right front speaker (F
-
R)↔Left rear speaker (R
-
L)↔Right rear speaker (R
-
R)↔Left subwoofer
*
(SW-
L)↔Right subwoofer
*
(SW-R)
* When the mega bass mode is turned off, adjustments cannot be made.
2 Turn the knob to adjust the distance or time correction unit of the speaker selected, and then short press the
knob.
Milliseconds: 0.000ms~10.000ms (0.01ms/level)
Centimeters: 0~346cm (0.3cm/level)
Inches: 0~136inch (0.1inch/level)
By setting these values, the speaker's sound can reach the listener's location at the same time as the sounds of
other speakers.
Note:
The sum of adjustable distances of all speakers shall be less than 510 centimeters/201 inches/15
milliseconds.
Options of time correction unit: ms (millisecond)/cm (centimeter)/inch
Adjust divider settings
Before performing the following steps, refer to “About the divider”.
1 After selecting divider settings in the sound effect setting mode, turn the knob to select the desired sound
channel, and then short press the knob.
Active division by 2
Front speaker ↔ Rear speaker ↔ Subwoofer*