26
-EN
01GB05IVAW200.fm
ALPINE IVA-W200 68-04123Z67-A (EN)
Switching Display Modes
After carrying out the steps 1 to 3 of “To display the DVD mode
Screen” explained on page 27, perform the operation described below.
While your vehicle is parked, touch
[WIDE]
on the visual
source screen.
Each touch changes the display modes as follows:
In Mode 1 (Wide), the monitor displays a normal picture wider to
fit in a wide-screen monitor by evenly stretching out the picture
horizontally.
In Mode 2 (Cinema), the monitor displays a normal picture by
stretching out the picture horizontally and vertically. This mode is
good for displaying a cinema type picture at the 16:9 ratio.
In Mode 3 (Normal), the monitor displays a normal picture at the
center of the screen with a vertical black band at each side.
Switching the Visual Source Only
(Simultaneous Function)
You can watch the video portion of another source while listening to the
current source.
•
After carrying out the steps 1 to 3 of “To display the DVD mode
Screen” explained on page 27, perform the operation described
below.
1
Touch
[VISUAL]
on the audio source screen.
The VISUAL selection screen appears.
2
Touch a desired visual source.
The visual source is switched to the selected one.
1
Touch the visual screen to display the main control.
2
Touch
[CONTROL]
.
3
Touch
[VISUAL]
within 5 seconds.
The VISUAL selection screen appears.
4
Touch
[NORMAL]
.
The simultaneous function is canceled.
•
To make the setting, set to “Setting the VISUAL Soft Button” (page
35).
•
If a DVD player is connected, you can receive the DVD picture/
sound.
DVD changer (DHA-S680) is connected:
Press and hold
V.OUT
on the remote control supplied with the DVD
player or DVD changer for more than 2 seconds. The picture and
sound of the DVD will be output.
The DVA-5210 is connected:
Press
V.OUT
on the remote control (included with the DVA-5210) to
output DVD picture/sound.
•
The simultaneous function cannot be used when the Audio source is
in the navigation mode.
When NAV. is set in “Setting the VISUAL Soft Button” (page 35), only
the navigation screen can be recalled.
Blackout Mode On and Off
When Blackout mode is turned on, the monitor display will turn off to
reduce power consumption.
This additional power enhances the sound quality.
1
Touch
[VISUAL]
on the main source screen.
The VISUAL selection screen is displayed.
2
Touch
[OFF]
.
The backlit-display portion goes out.
3
Touch
[OFF]
again to cancel the display backlight.
•
To make the setting, set to “Setting the VISUAL Soft Button” (page
35).
•
If any button on the unit is pressed during Blackout mode, the
function will be displayed for 5 seconds to show the operation before
returning to Blackout mode.
MODE 1
MODE 2
MODE 3
MODE 1
(WIDE)
(CINEMA)
(NORMAL)
(WIDE)
Cancelling the Simultaneous Function
01GB00IVAW200.book Page 26 Tuesday, December 20, 2005 11:41 AM
Summary of Contents for IVA W200 - DVD Player With LCD Monitor
Page 77: ...LIMITED WARRANTY ...
