87
-EN
Connection Diagram of SPST Switch (sold separately)
(If the ACC power supply is not available)
•
If your vehicle has no ACC power supply, add an SPST (Single-Pole, Single-Throw) switch (sold separately) and fuse (sold separately).
•
The diagram and the fuse amperage shown above are in the case when INE-W990BT is used individually.
•
If the switched power (ignition) lead of the INE-W990BT is connected directly to the positive (+) post of the vehicle
’
s battery, the INE-W990BT
draws some current (several hundred milliamperes) even when its switch is placed in the OFF position, and the battery may be discharged.
INE-W990BT
(Red)
(Yellow)
SPST SW (Optional)
FUSE (5A)
(Optional)
FUSE (20A)
(Optional)
Battery
ACC
BATTERY
To prevent external noise from entering the audio system.
•
Locate the unit and route the leads at least 10 cm away from the car harness.
•
Keep the battery power leads as far away from other leads as possible.
•
Connect the ground lead securely to a bare metal spot (remove any paint, dirt or grease if necessary) of the car chassis.
•
If you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine dealer carries various
noise suppressors, contact them for further information.
•
Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information.
Summary of Contents for INE-W990BT
Page 97: ......
