DLM-600 installer & user manual Rev. 1.3
16-11-2011
18 / 39
figure 7. Miscellaneous programming
O
UTPUTS
The DLM-600 has a total of four outputs, 2 are relay contacts and 2 are open collector outputs. OC3 and
OC4 are equipped with an automatic fuse (polyswitch) of 200mA. Jumpers J32 and J33 are used to
determine whether the relay contacts operate as normally open (n.o.) or as normally closed (n.c.).
Event
For each output you can program for which event it is activated. The different events are:
Telephone line failure
of the DLM-600 dialer. The DLM-600 has a line voltage sensing circuit and
checks every 3 seconds for the presence of the telephone line. If the line voltage is too low then a
telephone line failure event will be generated.
Fail to Communicate (FTC)
of the DLM-600 dialer. If the calling cycle (per input) of the DLM-600
dialer has been completed and the message is not received and / or accepted, a fail to communicate
event will be generated.
Mains Failure (230V)
of the DLM-600 dialer. If the mains voltage is not present a mains failure event
will be generated.
Battery failure
of the DLM-600 dialer. If a battery pack is connected to the DLM-600 (and enabled in
the programming) then a battery failure event will be generated when the battery voltage is too low.
Power supply failure
in the DLM-600 dialer. The power supply failure event depends on 'Supply
Drop' and 'Battery fault. If one of the two events occurs then the output will be activated.
DTMF control 1 to 3
of the DLM-600 outputs. This output can be controlled remotely using a DTMF
telephone.
CMK detection circuit open.
The outer 2 wires of the RJ11 connector/cable is open which could
indicate that the cable between the external PSTN dialer or analog dialer in the control panel has been
tampered with.
RS-485 bus trouble.
If the RS-485 connection is used and there is no communication between the
DLM-600 and the external control panel then an event is generated.
GPRS primary dialer trouble.
If the primary GPRS dialer does not function correctly an even will be
generated.
