Appendix D: RELEASE NOTES
With software version 2.0 of the AlphaVision NG control panel the following changes are made:
Added functions:
NG Prox Reader
Printer module NG. The Printer module NG now prints all overviews of the AlphaVision NG and
the AlphaVision 96. When printing the historic overview, the new overview with the 250 last events
is printed. Also the possibility to print the timer switch settings is added. The logprinter now also
prints events from the NG Prox Reader and medical alarms.
Up/downloading ISDN
The L.S. output of the control panel can now be used for the doorbell and RTC prealarm functions.
Improved functions:
Printing the installation overviews 1 (?14#) and 2 (?15#) were swopped. With version 2.0 the correct
overviews are printed when the corresponding functions are executed.
When the main user code was not programmed to the 8 sections, some system reports could not be
deleted when function 22 was accessed by pressing <#> directly. This is now solved.
Programming the delay time of the speaker output of the control panel did not function properly.
This is solved with version 2.0.
When 6 wrong user codes were entered this was reported to the central station, but not saved in the
historic overview. This is solved with version 2.0.
When a zone was in alarm and set to type 0 with function 28, the alarm could no longer be deleted
with function 22. This is now solved.
The buzzer output was not always activated with user code levels 1, 2 and 7. This is solved in
version 2.0
When the reset jumper is shorted (on the control panel PCB) the date and time stays saved.
Manual: version 2.0 August 2003 [CPR]
Translation: N. Pegtol
AlphaVision NG installation manual Rev. 2.0 27-08-2003 Blz. 101/101
Copyright: Alphatronics b.v.