Alpha One FALCON SPERBER mini DMX 2000W, Instructions For Use Manual

Page: 12 / 26

- 12 –
Version 2.0 November 2008
3.5 Installation - xenon illuminant
The following instructions and safety measures should be observed when installing
the xenon illuminant:
•
Handle the illuminant only in the safety packaging provided for this
purpose.
•
When handling xenon illuminants, it is obligatory to wear appropriate
protective clothing (face protection, leather jacket, and leather gloves).
See attachment "Handling OSRAM XBO illuminants".
•
Before opening the lamp, ensure that the equipment is disconnected
from the mains, and that it cannot be switched on again unintentionally.
•
To be able to replace the illuminant the upper glass holding plate must
be removed from the lamp housing.
•
After removing the brass M8 nut on the ignition rod, the anode cable
can be released.
•
The illuminant can now be unscrewed from the illuminant socket by an
anticlockwise turning motion.
•
After the illuminant has been placed safely in the protective packaging
provided for this purpose, the threaded brass socket must be removed
from the cathode connection of the illuminant. The socket is held in
place by two M3 grub screws with Allen key heads.
•
When installing a new illuminant, the brass socket should be refitted to
the illuminant and fixed with the grub screws.
•
The installation of the new illuminant is made into the lower illuminant
holder by means of a clockwise turning motion.
•
Special care must be taken here that the illuminant is not screwed in too
firmly or with excessive force, as this may result in the bursting of the
illuminant.
•
After the anode cable has been reconnected to the ignition rod and fixed
with the M8 nut, the glass holding plate must be refitted.
•
After the illuminant has been replaced, it is necessary to readjust the
beam.