»
masters
The first thing you will see is a list of all Masters that have been setup on this local network. Whenever a new AlphaECall™ 200
Master is connected to this network, you will be prompted as to whether it should be added in to this list automatically as a new
Master, or if it will be used to replace another master. You will never need to manually add a master to the list. Use the Remove
buttons to delete Masters that are no longer being used.
To configure the settings for a specific master, click the list item with that master’s name and you two tabs (“Setup” and “Options”)
appear.
»
Masters: Setup
Master Name
- This is the name you would like to call this master.
What type of device is connected to this Master?
- This is where you specify any serial hardware that may be connected to
this Master. Each Master can only have one serial device connected to it. The option to select from are:
•
None
• STR Translator
• Wireless Network Coordinator
• Pager Transmitter
• Central Station Dialer
• Relay Board(s)
Zones
- If you have any Zones setup you will see a list of checkboxes. One for each zone. Zones are optional. When using
26
Summary of Contents for AEC200DM
