2
CHECK YOUR BOXES
Be sure to immediately check your boxes against your shipping list and bill of lading. Examine for any damage and and
notify Almost Heaven Saunas if there needs to be a repair or replacement of damaged or missing materials.
ELECTRICAL REQUIREMENTS
All electrical wiring must be performed by
A QUALIFIED LICENSED ELECTRICIAN
. Because of the heat involved in the
sauna, it is required that you use copper wire with 90ºC insulation. Do not use aluminum wire to make the connection.
Consult with an electrician so you can determine the requirements for your particular situation. All wiring must conform
to all national, state and local codes and regulations and according to the instructions provided with the heater.
LOCATING THE SAUNA
Your Blue Ridge Sauna is designed for indoor use. Be sure your sauna is installed on a floor that is firm and flat. In-
stalling on carpet is not advised due to both the water that will be used in the sauna as well as the difficulty in assembly
on a soft surface. A concrete, tiled or vinyl surface are recommended as ideal surfaces for installation.
ASSEMBLY
You should use two people for the assembly of the Blue Ridge Sauna. The wall and roof sections are large and need
two people to lift and hold in place during assembly.
BASIC TOOLS
You should have the following tools:
Cordless drill for driving screws
Stepladder or stool
Rubber Mallet
Claw hammer
Screwdrivers (Phillips and Flathead)
Framing Square
Utility knife
Level
Read this entire manual through to the end before proceeding with the assembly.
