10
26. Attach Washer to VENT COVER
Put a 2” screw through the hole of the vent cover
and then place the washer over the screw as
shown.
Attach Washer to Vent Cover
27. Attach VENT COVER
Screw the Vent Cover over the vents on Wall Sec-
tion B using the pre-drilled hole.
NOTE:
Tighten only enough so vent cover will
turn freely over vents.
Attach Vent Cover
Attach Door Handles
28. Attach DOOR HANDLES
The door handle assembly will consist of the fol-
lowing components: 2-Door handles, 1- Male ma-
chine screw, 1-Female machine screw, 2-Square
Wooden Spacers, and 2-Round Wooden Spacers.
Locate the single hole in the glass door. Push one
machine screw through one of the pre-drilled han-
dles, through a round wooden spacer, through the
glass, and into the other machine screw, which has
already been pushed through the other door handle
and another round wooden spacer. Tighten the
screws to a point where the handle is secure on the
door, but still rotates freely. With a level, position
each of the handles so that they are horizontal and
then screw the end of the handles into the hinge
board that is attached to the glass door with the
wood screws. Now tighten the long machine
screws. TAKE CARE THAT YOU DO NOT
OVER TIGHTEN AND BREAK THE GLASS.
