ALMAC MULTI-LOADER 2.5, Translation Of Original Instructions

Page: 61 / 121

PAGE
61 ALMAC s.r.l.
4.2.2.3.1 Dynamic Levelling ON
During translation the levelling is automatically performed to ensure the loading
platform is always parallel to the ground in any translation mode.
4.2.2.3.2 Dynamic Levelling OFF
During translation the loading platform remains fixed and is not self-levelling. If
the DC-S mode is selected, they are automatically inserted:
-
Booster: the hydraulic motors are connected in series with consequent
doubling of the speed.
-
the displacement change of hydraulic motors: they are activated in small
displacement allowing a further increase in speed (reducing the traction
capacity)
To use this function in the best way, it is advisable to control both Joysticks in
the desired direction first and then move selector 6 from DM to DC-S.
At this point it is possible to release the left joystick and to keep holding only
the right one. The machine will continue to move straight at maximum speed.
Attention: It is not possible to perform the reverse procedure; once the machine
travels in DC-S it cannot go back to DM, not even if selector 6 is moved.
It is only possible to stop the machine completely by releasing the right joystick.
Attention: When the joystick is released, the machine will not stop immediately
bit there is a deceleration ramp. The space travelled before it stops can even be
of 50 cm.