ALMAC AlmaCrawler JIBBI 1250 EVO, Translation Of Original Instructions, Page: 66 / 233

PAGE 66 ALMAC s.r.l.
translation when inclination of the frame with respect to the horizontal exceeds 1°. Release
the travel control; when this control is operated again or when the lifting control is operated,
the system must bring the frame back to the horizontal position automatically. At the end of
levelling, the machine executes the selected movement; (Note: If the change in inclination is
sudden it is likely that the machine will stop with a tilt of the frame greater than 1°. Up to an
inclination of 4° automatic levelling is permitted; over 4° it is necessary to bring the platform
back into the transport condition);
•
Lift the platform to a height greater than the transport height, check that the manual levelling
functions are not permitted;
•
Operate the emergency button on the remote control (or radio control); make sure that the
engine turns off (both the internal combustion engine and the electrical engine) and that no
functions are allowed. Release the mushroom-shaped button after this test;
•
Operate the ground movement emergency button; make sure that the engine turns off (both
the internal combustion engine and the electrical engine) and that no functions are allowed.
Release the mushroom-shaped button after this test;
•
Press the emergency button on the basket support (only present in the radio version), check
that the engine (both endothermic and electric) is switched off and that no function is
permitted. Release the mushroom-shaped button after this test;
•
Operate the warning buzzer and make sure it works;
•
Check the operation of the buzzer when the drive function is activated;
•
Verify with machine in translation and platform in transport position that releasing the Joystick
the machine stops immediately;
•
Check the correct operation of the manual emergency descent device (Hand pump);
•
Get on the platform and check from the display that the load control system measures the
correct weight (tol-5Kg/11lbs);
•
In case non-perfect sealing of one of the cylinder valves is found (Example: the machine is
found with the telescopic boom lowered in relation to the position in which it was left, the
inclined basket is found), do not use the machine and contact an authorised service centre.
2.12 Precautions when work terminates or is interrupted
It is forbidden to leave the MEWP in configurations other than that of rest and without first having
made sure that the engine has been switched off and the keys removed from the control panel in
order to avoid use by unauthorised persons.
2.13 Personal protective equipment (PPE)
To operate the machine in complete safety is necessary to use appropriate personal protection
equipment, which must be worn before climbing on the basket and used as indicated.
-
Retaining system;
-
Safety helmet;
-
Safety shoes;
-
Protection gloves;