Allremote Wireless Technology, 2006/12/20
1
RRC065A User Manual
1.) Into Duplication Mode:
Make sure “”SW” is on “UP” position.
Press and hold all buttons on RRC065A, blue LED flashing 3 times shortly and 3 seconds
later will light on still, now please releasing buttons. It Had into Duplication Mode now.
2.) Duplicating Code:
2-1. Please be sure RRC065A
had in Duplication Mode.
“SW” has to be on “up” position
then press any one of
RRC065A button still, Blue LED
will keeping flashing.(It
means that in real Duplication
situation)
2-2. Releasing all buttons, and
please push “SW” to the
down position.
2-3. Please take original remote
and press button still also,
close to RRC065A right side to
find and searching till
RRC065A red indicator LED
indicating more brighter, It
means to the best duplicating position. then press desire button on RRC065A blue LED
will flashing once (It means done), what if blue LED keeping flashing or not light off.(It
means fail), please go back procedure 2-2.
2-4. Push SW1 up.
3.) Finishing Duplicating:
3-1. press all RRC065A together till blue LED flashing once, it means all Done and can be
used.
3-2. What if duplication & set up fail,(Can not remote by RRC065A ),please repeat
procedure 1.) 2.) and 3.) once again.
※
Normally press any RRC065A button, it emits including 4 type Frequency (390MHz /
318MHz / 310MHz / 300MHz) Main receiver will operate in 5 seconds, if you need to
re-emitting signal by RRC065A , Please releasing all buttons after blue LED light’s off and
repress once again.
GENIE’S Garage Door operation
1.) Following same way with RRC065A Duplication Mode, Duplicating Genie’s
Remote unit code into RRC065A.
2.) Please Following Genie’s Original User Manual, and learning RRC065A as
new group for setting up.
