25 August 2016
16
LPAssem Version 1.1
•
Carefully screw in 4 screws to hold each of the pickup rings down. Do not over tighten.
5.11.
Make Connections
All wire connections are done using snap together connectors. While we have had no issues with these
connectors, if you prefer a more traditional connection, you can solder the wires together.
•
Connect the two conductor connector from the jack to the two conductor connector coming from the
switch. ()
•
Connect the two female connectors from the switch to the two male connectors on the volume
controls.
•
Connect the two pickups connectors to the appropriate connectors on the volume controls.
•
After you have finished the setup steps below, you can put the covers on the back of the guitars. But
wait until then so that you can correct any problems with the wiring first.
Figure 37 Neck Pickup
Figure 38 Bridge Pickup
Figure 39 Output connector
Figure 40
Troubleshooting!
•
You may have to rearrange the wires several times to get them into body. It can be a tight fit. Be
patient and don’t force things as this can bend components and break wires.
