INSTRUCTIONS
Programming from an already activated remote control:
1.
Press both buttons on the working remote control until the light flashes
2.
When the LED flashes, press and hold the button you normally use for operating your
system
3.
Put the remotes head to head and press and hold in the same button on the new remote
control
4.
The LED will flash 3 times and then goes out
5.
Your new remote control is now programmed
Programming on the receiver:
1.
Power up the system after installing and connecting the electrical components of the 868
SLH System (fig.1).
2.
Use a master TX to set the “system code” on the decoding card/RP receiver (see “system
coding”).
3.
Use the same master TX to set the system code on the system's other TXs
4.
Coded TXs are automatically stored in the decoding card/ RP receiver by simply
activating the transmitter channel twice in succession within 5 seconds.
Visit our website: www.Alloremotecontrol.com
FAAC SLH
Visit our website: www.Alloremotecontrol.com
