ALL7000
Quick Installation Guide / Express Setup
- 16 -
Step 4
Click on the Policy tab from the main function menu and then click on Outgoing
from the sub-function list.
Click on New Entry button.
When the New Entry option appears, then enter the following configuration:
Source Address – select “Inside_Any”
Destination Address – select “Outside_Any”
Service - select “ANY”
Action - select “Permit”
Click on OK to apply the changes.
Step 5
The configuration is successful if you see the screen below. Make sure that all the
computers that are connected to the LAN port have their Default Gateway IP Address
set to the ALL7000 LAN IP Address (i.e. 192.168.1.1). At this point, all the computers
on the LAN network should gain access to Internet immediately. If an ALL7000 filter
function is required, please refer to the Policy section.
