ALL168205 NANO Quick Installation © 2012 ALLNET GmbH All rights reserved Page 6
Product installation guide
Important:
Do not plug the device into a power strip or surge protector because these devices may
include filter circuits and impair the signal. Also avoid plugging in the device right next to noisy
sources such as cell phone chargers, halogen light, energy saving bulb, noisy desktop computer,
vacuum cleaner, etc. Both cases can result in poor or decreased transmission speed.
To install for the PC local Powerline network
1.
Use the supplied Category 5 Ethernet cable to connect Ethernet Bridge and your PC
’s Ethernet port.
2.
Plug the Ethernet Bridge to outlet.
3.
The PWR-LED indicator will light on after plugging.
4.
You can repeat steps 1 and 2 for connecting the others
.
5.
The PLC-LED indicator is lit if a powerline-connection is established and starts blinking when data
communication proceeds on Powerline. The color of this LED shows the quality of the PLC-link. Green
indicates a good connection speed, orange is medium speed and red signals low connection speed. The more
exact speed values can be shown by the configuration-utility.
6.
The ETH-LED indicator is lit when the adapter has a working ethernet-link and starts blinking when data
communication proceeds on Ethernet.
To share an xDSL or cable modem with Internet access service
1.
Connect one Ethernet Bridge to the broadband router
Plug the Ethernet Bridge into an AC outlet.
Plug the provided Ethernet cable into the RJ45 connector of the Bridge and plug the other end of the
cable into an available Ethernet port of the Router.
2.
Connect the other Ethernet Bridge(s) to the PC(s) to share the Internet access
Plug the Ethernet Bridge into an AC outlet.
Plug the provided Ethernet cable into the RJ45 connector of the Bridge and plug the other end of the
cable into the Ethernet port of the PC.
