Figure 20 (Ping test)
4.7.5 Modem Test
The Modem Test is used to check whether your
ADSL Router is properly connected to the WAN
Network. This test may take a few seconds to com-
plete. To perform the test, select your connection
from the list and press the Test button. Before run-
ning this test, make sure you have a valid DSL link;
if the DSL link is not connected, this test will always
fail.
Also the DSLAM must support this feature; not all
DSLAMs have F4 and F5 support.
4.8 Status
The Status section allows you to view the Status/
Statistics of different connections and interfaces
4.8.1 Network Statistics
Select to view the Statistics of different interfaces -
Ethernet/USB/DSL.
4.8.2 Connection Status
Select to view the Status of different connections.
4.8.3 DHCP Clients
Select to view the list of DHCP clients.
4.8.4 Modem Status
Select to view the Status and Statistics of your bro-
adband (DSL) connection.
4.8.5 Product Information
You can display the ADSL Router’s driver and run-
time information by going under Status title and
click on Product Information. Figure 21 illustrates
the typical product information, which is provided.
Figure 21 (Product Information)
4.8.6 System Log
You can display the ADSL Router’s log by going
under the Status title, click System log. From here
you can view all logged information. Depending
upon the severity level, this logged info will genera-
te log reports to a remote host (if remote logging is
enabled).
ALL 0333AU – DSL ETHERNET MODEM ROUTER
A L L N E T
®
2 0 0 4
1 9
ALL0333AU_Manual_a 07.04.2004 14:12 Uhr Seite 19
