not have spaces and cannot begin with numbers. In
this case the unique name is called STATIC1. Select
the encapsulation type (LLC or VC); if you are not
sure just use the default mode. Select the VPI and
VCI settings; your DSL service provider or your ISP
will supply these; in this case the DSL service provi-
der is using 0,35. Also select the quality of service
(QOS); leave the default value if you are unsure or
the ISP did not provide this information. You can
also enable Network Address Translation (NAT) and
the Firewall options. If you are unsure, leave these
in the default mode.
Based upon the information your DSL/ISP provided,
enter your assigned IP address, Subnet Mask,
Default Gateway (if provided), and Domain Name
Services (DNS) values (if provided). For the static
configuration, you can also select a bridge connec-
tion or a routed connection. Since static IP address
is typically used to host WEB servers, you may want
to use a bridge connection.
Figure 8 (Static IP Connection Setup)
To complete the connection you must now click the
apply button. The apply button will temporarily save
this connection. To make the change permanent you
need to click on Save Settings (at the side of the page).
At the system commands page, click on Save All.
4.4.1.6 Classical IP over ATM (CLIP
defined in RFC1577) Connection Setup
The Classical IP over ATM (CLIP) support provides
the ability to transmit IP packets over an ATM net-
work, CLIP support will encapsulate IP in an AAL5
packet data unit (PDU) frame using RFC1577and it
utilizes an ATM aware version of the ARP protocol
(ATMARP. support only allows for PVC support; it
does not support SVC).
To configure the ADSL Router for a CLIP connection,
click on Setup and then click on New Connection.
The default CLIP connection setup is displayed. At
the Type field select CLIP and the CLIP connection
setup page is displayed; figure 9 illustrates a typical
CLIP configuration. Give your CLIP connection a
unique name; the name must not have spaces and
cannot begin with numbers. In this case the unique
name is called CLIP1. Select the VPI and VCI set-
tings; your DSL service provider or your ISP will sup-
ply these; in this case the DSL service provider is
using 0,101. Also select the quality of service (QOS);
leave the default value if you are unsure or the ISP
did not provide this information. You can also ena-
ble Network Address Translation (NAT) and the Fire-
wall options. If you are unsure, leave these in the
default mode.
Figure 9 (CLIP Connection Setup)
To complete the connection you must now click the
apply button. The apply button will temporarily save
this connection. To make the change permanent you
need to click on Save Settings (at the side of the page).
At the system commands page, click on Save All.
ALL 0333AU – DSL ETHERNET MODEM ROUTER
1 0
A L L N E T
®
2 0 0 4
ALL0333AU_Manual_a 07.04.2004 14:12 Uhr Seite 10
