Allmatic TeleCentric 70 M, Operating Manual, Page: 53 / 401

ALLMATIC Description | 6
TeleCentric 53 / 400
6 Description
1
3
4
5
6
2
2
Fig. 7: Product description
1 Inner spindle 4 Screw plug
2 Spindle nut 5 Lower section
3 Outer spindle for socket spanner insert
WAF 14 6 Centre column
When the outer spindle (3) is turned clockwise with a torque spanner, the inner and outer
spindles (1, 3) move into each other and the spindle nuts (2) move in the direction of clamping.
The spindles (1, 3) remain flush with the spindle nuts (2). The TeleCentric can be fixed to the
machine table via the screw plugs (4) and the boreholes on the lower section (5). The zero point
can be finely adjusted on the middle column (6).
Avoid excessive torque.
Damage to the TeleCentric.
Ø
Set the torque spanner used to max. 45 Nm (30 kN clamping force) .
EN