Triggering
207
Goldeye G/CL Technical Manual V4.2.0
Test conditions
•
External 2.4 k
Ω
resistor to GND
•
Power input for output ports set to 12 V
Control signals
It is possible to configure the I/Os of the camera, using software. The different
modes are described on the following pages.
Inputs
I/O pin control
All I/O signals running over the camera I/O connector are controlled by the I/O
strobe commands. For more details see the Goldeye G/CL Features Reference.
Cycle delay
The cycle delay for the Goldeye is as follows:
•
t
pdLH
< 3.5 µs
•
t
pdHL
< 30 µs
For this reason, we recommend triggering on the rising edge. This ensures the
fastest possible reaction time.
Figure 63: Goldeye G/CL input signal block diagram
