Manta Technical Manual V7.0.3
87
Camera interfaces
Camera I/O connector pin assignment (incl. PoE)
The General Purpose I/O port uses a Hirose HR10-10R-12PA(73) connector on
the camera side. The mating cable connector is Hirose HR10A-10P-12S.
Note
From serial number
503323258
onwards all Manta models
including PoE and board level versions contain the same main
board:
•
All I/O circuits have the same properties.
•
For
Manta models with serial number ≤ 503323258
:
Camera I/O connector pin assignment
Pin Signal
Direction Level
Description
1 Camera GND
In
GND for RS232 and
ext. power
Ground for camera
power supply and RS232
2 Camera Power In
8–30 V DC
Camera power supply
3 Video Type
Auto Iris Out
Out
---
Video type auto iris
(
FW 1.44)
4 In 1
In
Standard and PoE
cameras:
U
in
(high) = 3–24 V
up to 36 V with external
resistor of 3.3 k
in series
U
in
(low) = 0–1.0 V
Input 1 (SyncIn1)
5 ---
---
---
---
6 Out 1
Out
Open emitter, max. 10 mA
Output 1 (SyncOut1)
7 Isolated IO
GND
In/Out
Common GND for In/Out
Isolated input and out-
put signal ground
8 RxD RS232
In
RS232
Terminal receive data
9 TxD RS232
Out
RS232
Terminal transmit data
10 Isolated Out
Power
In
Common VCC for outputs
max. 30 V DC
Power input for
opto-isolated outputs
11 In 2
In
Standard and PoE
cameras:
U
in
(high) = 3–24 V
U
in
(low) = 0–1.0 V
Input 2 (SyncIn2)
12 Out 2
Out
Open emitter, max. 10 mA
Output 2(SyncOut2)
Table 32: Camera I/O connector pin assignment
Note
Read all
Notes
and
Cautions
in the
before using the I/O connector.
Note
The cable side Hirose connector is available for purchase
from AVT.
AVT P/N: K7600040
1
2
3
4 5 6
7
8
9
10
12
11
