Configuration of the camera
PIKE Technical Manual
V5.0.0
355
Frame time control
With this register you can set the frame time (in microsecends) and thus con-
trol the sensor frame rate more precisely than with the BytesPerPacket set-
tings.
•
The precision of the frame rate depends on the jitter at start of expo-
sure: see
•
The frame rate is affected by both: current shutter time and
BytesPerPacket setting.
Note
•
A profile save operation automatically disables captur-
ing of images.
•
A profile save or restore operation is an uninterruptable
(atomic) operation. The write response (of the asyn-
chronous write cycle) will be sent after completion of
the operation.
•
Restoring a profile will not overwrite other settings
than listed above.
•
If a restore operation fails or the specified profile does
not exist, all registers will be overwritten with the
hard-coded factory defaults (profile #0).
•
Data written to this register will not be reflected in the
standard memory channel registers.
Note
•
The image transport speed depends on the
BytesPerPacket setting only.
•
The camera corrects invalid values automatically.
Offset
Name
Field
Bit
Description
0xF1000A00
FRAMETIME_CTRL Presence_Inq
[0]
Indicates presence of this feature
(read only)
---
[1..5]
Reserved
OnOff
[6]
Enables or disables frame rate
control
---
[7]
Reserved
FrameTime
[8..31]
Frame time in microsecond steps
0xF1000A04
MinValue
[0..31]
Minimum frame time
0xF1000A08
MaxValue
[0..32]
Maximum frame time
Table 186: Advanced register:
Frame time control
