Allied Telesis XS910/8, Manual

Page: 53 / 62

Chapter 5: Installation Using the AT-RKMT-J15 Rack Mount Kit
53
Installing Two Switches in a Row of the Equipment Rack
This section shows you steps to install two switches on a row of the
equipment rack using the AT-RKMT-J15 rack mount kit.
What to Prepare
Before installing two switches on a row of the equipment rack, make sure
that the following items are ready.

One AT-RKMT-J15 tray

Four M4x6mm screws (Included in the AT-RKMT-J15 kit)

Four screws for the equipment rack (Not included)

Phillips-head screwdriver (Not included)
Installing Two
Switches in a Row
of the Equipment
Rack
To install the switch on a wall, perform the following procedure:
1. Review “Reviewing Safety Precautions” on page 26 and “Selecting a
Site and Planning the Installation” on page 29.
2. Place all the items from the packaging on a work table.
3. Mount the AT-RKMT-J15 tray in a 19-inch equipment rack using four
equipment rack screws. See Figure 22
x
Figure 22. Installing the AT-RKMT-J15 Tray in an Equipment Rack