Allied Telesis x510-28GPX, Command Reference Manual

Page: 912 / 2822

C613-50170-01 Rev B Command Reference for x510 Series 912
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
RIP C
OMMANDS
IP RIP RECEIVE VERSION
ip rip receive version
Overview Use this command to specify the version of RIP packets accepted on an interface
and override the setting of the version command.
Use the no variant of this command to use the setting specified by the version (RIP)
command.
Syntax
ip rip receive version {[1][2]}
no ip rip receive version
Default Version 2
Mode Interface Configuration for a VLAN interface.
Usage This command can only be used on VLAN interfaces.
This command applies to a specific VLAN interface and overrides any the version
specified by the
version (RIP) command.
RIP can be run in version 1 or version 2 mode. Version 2 has more features than
version 1; in particular RIP version 2 supports authentication and classless routing.
Once the RIP version is set, RIP packets of that version will be received and sent on
all the RIP-enabled interfaces.
Example In the following example, the VLAN interface
vlan3
is configured to receive both
RIP version 1 and 2 packets:
awplus# configure terminal
awplus(config)# interface vlan3
awplus(config-if)# ip rip receive version 1 2
Related
Commands
version (RIP)
Parameter Description
1
Specifies acceptance of RIP version 1 packets on the interface.
2
Specifies acceptance of RIP version 2 packets on the interface.