Allied Telesis x510-28GPX, Command Reference Manual

Page: 870 / 2822

C613-50170-01 Rev B Command Reference for x510 Series 870
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
IP
V
6 C
OMMANDS
SHOW IPV
6
ROUTE
show ipv6 route
Overview Use this command to display the IPv6 routing table for a protocol or from a
particular table.
For information on filtering and saving command output, see the “Getting Started
with AlliedWare Plus” Feature Overview and Configuration Guide .
Syntax
show ipv6 route
[connected|database|ospf|rip|static|summary|
<ipv6-address> |

<ipv6-addr/prefix-length> )]
Mode User Exec and Privileged Exec
Example 1 To display an IP route with all parameters turned on, use the following command:
awplus# show ipv6 route
Parameter Description
connected
Displays only the routes learned from connected
interfaces.
database
Displays only the IPv6 routing information extracted
from the database.
ospf
Displays only the routes learned from IPv6 Open
Shortest Path First (OSPFv3).
rip
Displays only the routes learned from IPv6 Routing
Information Protocol (RIPng).
static
Displays only the IPv6 static routes you have configured.
summary
Displays summary information from the IPv6 routing
table.
<ipv6-address>
Displays the routes for the specified address in the IP
routing table. The IPv6 address uses the format
X:X::X:X/Prefix-Length. The prefix-length is usually set
between 0 and 64.
<ipv6-prefix/length>
Displays only the routes for the specified IP prefix.