C613-50170-01 Rev B
Command Reference for x510 Series
287
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
S
YSTEM
C
ONFIGURATION
AND
M
ONITORING
C
OMMANDS
SHOW
SYSTEM
INTERRUPTS
show system interrupts
Overview
Use this command to display the number of interrupts for each IRQ (Interrupt
Request) used to interrupt input lines on a PIC (Programmable Interrupt Controller)
on your device.
For information on filtering and saving command output, see the
with AlliedWare Plus” Feature Overview and Configuration Guide
Syntax
show system interrupts
Mode
User Exec and Privileged Exec
Example
To display information about the number of interrupts for each IRQ in your device,
use the command:
awplus#
show system interrupts
Output
Figure 7-19:
Example output from the
show system interrupts
command
Related
Commands
awplus>show system interrupts
CPU0
1: 2 CPM2 SIU Level Enabled 0 i2c-mpc
2: 145 CPM2 SIU Level Enabled 0 spi-mpc
77: 0 OpenPIC Level Enabled 0 enet_tx
78: 2 OpenPIC Level Enabled 0 enet_rx
82: 0 OpenPIC Level Enabled 0 enet_error
90: 5849 OpenPIC Level Enabled 0 serial
91: 2066672 OpenPIC Level Enabled 0 i2c-mpc
94: 147 OpenPIC Level Enabled 0 cpm2_cascade
112: 5 OpenPIC Edge Enabled 0 phy_interrupt
114: 398714 OpenPIC Level Enabled 0 mvPP
115: 26247 OpenPIC Level Enabled 0 mvPP
119: 0 OpenPIC Edge Enabled 0 Power supply status
...
BAD: 0
