Allied Telesis x510-28GPX, Command Reference Manual

Page: 2608 / 2822

59
C613-50170-01 Rev B Command Reference for x510 Series 2608
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
LLDP Commands
Introduction
Overview LLDP and LLDP-MED can be configured using the commands in this chapter, or by
using SNMP with the LLDP-MIB and LLDP-EXT-DOT1-MIB (see the
Support for
Allied Telesis Enterprise MIBs in AlliedWare Plus ).
The Voice VLAN feature can be configured using commands in VLAN Commands
chapter.
For more information about LLDP, see the LLDP Feature Overview and
Configuration Guide .
LLDP can transmit a lot of data about the network. Typically, the network
information gathered using LLDP is transferred to a Network Management System
by SNMP. For security reasons, we recommend using SNMPv3 for this purpose (see
the
SNMP Feature Overview and Configuration Guide ).
LLDP operates over physical ports only. For example, it can be configured on switch
ports that belong to static or dynamic channel groups, but not on the channel
groups themselves.
Command List • “ clear lldp statistics ” on page 2610
• “ clear lldp table ” on page 2611
• “ debug lldp ” on page 2612
• “ lldp faststart-count ” on page 2614
• “ lldp holdtime-multiplier ” on page 2615
• “ lldp management-address ” on page 2616
• “ lldp med-notifications ” on page 2617
• “ lldp med-tlv-select ” on page 2618
• “ lldp non-strict-med-tlv-order-check ” on page 2621
• “ lldp notification-interval ” on page 2622
• “ lldp notifications ” on page 2623