C613-50170-01 Rev B
Command Reference for x510 Series
2255
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
A
LLIED
T
ELESIS
M
ANAGEMENT
F
RAMEWORK
™ (AMF) C
OMMANDS
ATMF
CONTROLLER
atmf controller
Overview
Use this command to configure the device as an AMF controller. This enables you
to split a large AMF network into multiple areas.
AMF controller is a licensed feature. The number of areas supported on a controller
depends on the license installed on that controller.
Use the
no
variant of this command to remove the AMF controller functionality.
Syntax
atmf controller
no atmf controller
Mode
Global configuration
Usage
If a valid AMF controller license is not available on the device, the device will accept
this command but will not act as a controller until you install a valid license. The
following message will warn you of this:
“An AMF Controller license must be installed before this feature will become
active”
NOTE
:
If the AMF controller functionality is removed from a device using the
no atmf
controller
command then the device must be rebooted if it is to function properly as
an AMF master.
Example
To configure the node named
controller-1
as an AMF controller, use the
commands:
controller-1#
configure terminal
controller-1(config)#
atmf controller
To stop the node named
controller-1
from being an AMF controller, use the
commands:
controller-1#
configure terminal
controller-1(config)#
no atmf controller
Related
Commands
