Allied Telesis x510-28GPX, Command Reference Manual

Page: 1514 / 2822

37
C613-50170-01 Rev B Command Reference for x510 Series 1514
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
IPv4 Software
Access Control List
(ACL) Commands
Introduction
Overview This chapter provides an alphabetical reference for the IPv4 Software Access
Control List (ACL) commands, and contains detailed command information and
command examples about IPv4 software ACLs as applied to Routing and
Multicasting, which are not applied to interfaces.
For information about ACLs, see the ACL Feature Overview and Configuration
Guide .
To apply ACLs to an LACP channel group, apply it to all the individual switch ports
in the channel group. To apply ACLs to a static channel group, apply it to the static
channel group itself. For more information on link aggregation see the following
references:
• the Link Aggregation Feature Overview_and Configuration Guide .
• Link Aggregation Commands
NOTE
: Text in parenthesis in command names indicates usage not keyword entry. For
example, access-list hardware (named) indicates named IPv4 hardware ACLs
entered as
access-list hardware
<
name
> where <name> is a placeholder not
a keyword.
Parenthesis surrounding ACL filters indicates the type of ACL filter not the keyword
entry in the CLI, such as
(access-list standard numbered filter) represents command
entry in the format shown in the syntax:
[< sequence-number >] {deny|permit} {< source-address >|host
< host-address >|any}
NOTE
: Software ACLs will deny access unless explicitly permitted by an ACL action.
Sub-modes Many of the ACL commands operate from sub-modes that are specific to particular
ACL types. The following table shows the CLI prompts at which ACL commands are
entered.