C613-50170-01 Rev B
Command Reference for x510 Series
1428
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
PIM-SM
V
6 C
OMMANDS
SHOW
IPV
6
PIM
SPARSE
-
MODE
RP
NEXTHOP
show ipv6 pim sparse-mode rp nexthop
Overview
Use this command to display the RP (Rendezvous Point) next hop information used
by PIM-SMv6.
For information on filtering and saving command output, see the
“Getting Started
with AlliedWare Plus” Feature Overview and Configuration Guide
.
Syntax
show ipv6 pim sparse-mode rp nexthop <
RP-group-addr
>
Mode
User Exec and Privileged Exec
Example
awplus#
show ipv6 pim sparse-mode rp nexthop 3ffe:10:10:5::153
Figure 34-14: Example output from the
show ipv6 pim sparse-mode rp
nexthop
command
Parameter
Description
<
RP-group-addr
>
Specify the RP group address used to display next hop RP
information, entered in the form X:X::X:X.
awplus#show ipv6 pim sparse-mode rp nexthop 3ffe:10:10:5::153
Flags: N = New, R = RP, S = Source, U = Unreachable
Destination Type Nexthop Nexthop Nexthop Nexthop Metric Pref Refcnt
Num Addr Ifindex Name
_____________________________________________________________________________________
3ffe:10:10:5::153 .RS. 1 fe80::20e:cff:fe01:facc 2 30 110 1
Table 3:
Parameters in output of the
show ipv6 pim sparse-mode rp nexthop
command
Parameter
Description
Destination
The destination address for which PIM-SMv6 requires next hop
information.
Type
The type of destination, as indicated by the Flags description. N =
New, R= RP, S = Source, U = Unreachable.
Nexthop Num
The number of next hops to the destination. PIM-SMv6 always
uses only 1 next hop.
Nexthop Addr
The address of the primary next hop gateway.
Nexthop
IfIndex
The interface on which the next hop gateway can be reached.
Nexthop Name
The name of next hop interface.
