1
Introduction
This document contains instructions to install a
device upright on a flat surface using the
STND-J03 Stand Kit.
Guidelines for Using the STND-J03 Stand Kit
The installation surface should be level and
secured.
If you plan to install a device against or by a
wall, make sure that the wall is straight and
secured.
A device can be installed upright by itself.
A device can be installed upright against a
wall.
Note
When installing a device upright against a wall,
you must place the bottom of the device to the
wall.
A device can be installed by a wall with space
between the device and wall.
STND-J03 Stand Kit Package Contents
The STND-J03 Stand Kit includes:
What to Prepare for Installation
STND-J03 Stand Kit
One device to install upright
Phillips-head screwdriver
Determining Which Screw Holes to Use
Determining which screw holes to use to install
your device depends upon an installation
orientation. The holes are marked with A, B or C.
Quick Installation Guide
STND-J03 Stand Kit
Two Stand
Brackets
Four Rubber Foot
Four Screws
(M4 x 6 mm)
One Hook-and-
Loop Fastener
By itself
Against a wall
By a wall
B
A
C
