Allied Telesis AT-x510-28GPX, Command Reference Manual

Page: 1613 / 2601

C613-50102-01 REV C Command Reference for x510 Series 1613
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
802.1X C
OMMANDS
SHOW DOT
1
X SUPPLICANT INTERFACE
show dot1x supplicant interface
Overview This command shows the supplicant state of the authentication mode set for the
interface, which may be a static channel (or static aggregator) or a dynamic (or
LACP) channel group or a switch port.
This command shows a summary when the optional brief parameter is used.
For information on filtering and saving command output, see the “Getting Started
with AlliedWare Plus” Feature Overview and Configuration Guide .
Syntax show dot1x supplicant interface < interface-list > [brief]
Mode Privileged Exec
Examples See sample output below showing the supplicant on the interface
port1.0.6
:
awplus# show dot1x interface port1.0.6
Parameter Description
<interface-list>
The interfaces or ports to configure. An interface-list can be:
• an interface (e.g.
vlan2
), a switch port (e.g.
port1.0.6
),
a static channel group (e.g.
sa2
) or a dynamic (LACP)
channel group (e.g.
po2
)
• a continuous range of interfaces, ports, static channel
groups or dynamic (LACP) channel groups separated by a
hyphen; e.g.
vlan2-8
, or
port1.0.1-1.0.4
, or
sa1-2
, or
po1-2
• a comma-separated list of the above; e.g.
port1.0.1,port1.0.4-1.0.6
. Do not mix interface
types in a list
The specified interfaces must exist.
brief
Brief summary of the Supplicant state.