Allied Telesis AT-TQ6602, Installation Manual, Page: 25 / 108

TQ6602 Wireless Access Point Installation Guide
25
Ethernet LAN Port
The wireless access point has one Ethernet LAN port on the rear panel,
with these operational properties:

10Mbps (IEEE 802.3), 100Mbps (IEEE 802.3u), 1000Mbps (IEEE
802.3ab), 2.5Gbps, and 5Gbps (IEEE 802.3bz)

Flow control (IEEE 802.3x)

VLAN tagging (IEEE 802.1Q)

Auto-Negotiation for speed and duplex mode

Auto-MDI/MDIX at 10/100Mbps
The port has the following functions:

You use it to connect the wireless access point to a device on your
wired network, such as Ethernet switch or router. The port makes it
possible for wireless clients of the wireless network to gain access
to the wired network.

The Ethernet LAN port can also be used to provide the electrical
power to the device. The wireless access point is a PoE powered
device, meaning it can be powered by a PoE power source on the
port. A PoE power source can be a PoE router or switch. such as
the x320-10GH Switch from Allied Telesis. Electrical power is
transmitted to the wireless access point by the power source over
the same network cable that carries the network traffic.
Power Over
Ethernet
You can power the wireless access point as a PoE+ Class 4 device on the
LAN port. Powering the device with PoE requires connecting the LAN port
to a PoE source device.
You can also power the device with an external AC/DC adapter, such as
the PWRADP-01 (DA-48Z12) Power Adapter. Refer to “How to Power the
Wireless Access Point” on page 28.
Connector Type
The LAN port has an eight-pin RJ45 connector. The port uses four pins in
the connector at 10/100 Mbps and all eight pins at higher speeds. Refer to
the tables in “Port Pinouts” on page 72 for the pin assignments.
Speed
The LAN port can operate at 10/100Mbps/1/2.5/5Gbps. The speed is set
automatically with Auto-Negotiation. You cannot disable Auto-Negotiation
on the port.