FS710 Series Ehternet Switch Installation Guide
23
Key Features
The FS710 Series switch has the following key features:
10/100 Mbps (10Base-T/100Base-TX) twisted pair Ethernet ports with
RJ-45 connectors
Auto-Negotiation (IEEE 802.3u-compliant) on all Ethernet ports
Auto MDI/MDI-X on Ethernet pair ports
Half- or full-duplex mode on all twisted pair ports
Flow control
– Full duplex: IEEE 802.3x-compliant
– Half duplex: back pressure
Storage of up to 2K MAC addresses for the AT-FS710/5,
AT-FS710/5E, AT-FS710/8 and AT-FS710/8E models.
Storage of up to 8K MAC addresses for AT-FS710/16, AT-FS710/16E,
and AT-FS710/24 models.
200 ~ 300 second MAC address aging time
Wire speed reception and transmission
Store-and-forward switching method
1536 Byte maximum frame length
2K bytes maximum Jumbo Frame size
Tagged VLAN packet pass through
BPDU packet pass through
Drops PAUSE frame
10/100Base-TX
Twisted Pair
Ports
The FS710 Series switches feature twisted pair copper ports.
Connector
All twisted pair ports feature 8-pin RJ-45 connectors. For the port pinouts,
see “RJ-45 Twisted Pair Port Connectors” on page 64.
Speed
The ports are 10Base-T, and 100Base-T compliant and are capable of 10
Mbps and 100 Mbps speeds. The ports are IEEE 802.3u Auto-Negotiation
compliant. With Auto-Negotiation, the switch automatically matches the
highest possible common speed between each switch port and each end-
node. For example, if an end-node is capable of only 10 Mbps, the switch
sets the port connected to the end-node to 10 Mbps.
