FS710 Series Ehternet Switch Installation Guide
41
Installing a Switch Using the AT-BRKT-J23 Wall Mount Kit
This section shows you steps to install an AT-FS710/8 switch on a wall
using the AT-BRKT-J23 kit. Before installing a switch on a wall, make sure
that the following items are ready.
An AT-BRKT-J23 wall mount kit
Eight M4 x 32mm round-head wood screws to attach the brackets
to a wall
Eight 6mm x 30mm nylon anchor plug for the screws. These
anchors are need only for sheet rock, concrete or cinder block
walls.
Phillips-head screwdriver
Pencil
Note
The screws, plastic anchors, screwdriver and pencil are not included
in the shipping box. You must provide the screws and anchors that
hold the switch securely to the wall.
Note
Refer to “Unpacking the Switch” on page 33 to remove the switch
and its components from the shipping box.
To install the AT-FS710/8 switch on a wall, perform the following
procedure:
1. Review the “Guidelines for Installing the Switch on a Wall” on page 35
before installing the switch.
2. Turn the switch upside down and remove the rubber feet by removing
the attaching screws. See Figure 18.
Figure 18. Removing the Rubber Feet
