AT-x220-28GS Switch Installation Guide
35
Starting a local management session
This procedure requires a terminal or a terminal emulator program and the
management cable that comes with the switch. To start a local
management session on the switch, perform the following procedure:
1. Connect the RJ45 connector on the management cable to the console
port on the front panel of the switch, as shown below.
Figure 23. Connecting the management cable to the console port of
the x220 Series Switch
27
28
25
26
21
23
22
24
FAULT
POWER
USB
ON
ACT
ERR
CLASS 1
LASER PRODUCT
CONSOLE
2. Connect the other end of the cable to an RS-232 port on a terminal or
PC with a terminal emulator program.
3. Configure the terminal or terminal emulator program as follows:
Baud rate: 9600 bps (The baud rate of the Console Port is
adjustable from 1200 to 115200 bps. The default is 9600 bps.)
Data bits: 8
Parity: None
Stop bits: 1
Flow control: None
Note
The port settings are for a DEC VT100 or ANSI terminal, or an
equivalent terminal emulator program.
4. If you have not already done so, power up the switch as described in
the previous steps.
Summary of Contents for AT-220-28GS Series
Page 8: ...vi ...
Page 10: ...viii ...
Page 26: ...Chapter 1 Overview 16 ...
Page 52: ...Chapter 2 Installation 42 ...