Patch 86241-02 For Rapier Switches and AR800 Series Modular Switching Routers
3
Patch 86241-02 for Software Release 2.4.1
C613-10340-00 REV B
The following issues have been resolved:
•
The RESET PIM INTERFACE=VLAN command was not working
correctly.
•
Packets with Time to Live (TTL) set to less than 4 were not being
forwarded.
•
VLAN tags were not being inserted into IP multicast packets on multi-
tagged ports.
•
A fatal error occurred when PIM and RIP were both running.
ARL message interrupts have been re-enabled after a software table rebuild
to fix synchronisation of the software forwarding database with the
hardware table.
The CREATE CONFIG command did not save the SOURCEPORT
parameter to the configuration file when the low value of the source port
range was set to zero. This issue has been resolved.
Report sending and default routes were not working correctly. Also, the
SHOW CONFIGURATION DYNAMIC and SHOW
CONFIGURATION=DVMRP commands were not working correctly. These
issues have been resolved.
TELNET sessions are now closed with “^D” only when the session is in the
login state.
DHCP now processes
Discover
messages smaller than 300 bytes.
IPSec no longer logs packets that match an ACTION=ALLOW policy. The
overhead of this logging was affecting non-IPSec traffic.
The LOCALRSAKEY parameter in the CREATE ISAKMP POLICY and SET
ISAKMP POLICY commands was not accepting the value zero. This issue
has been resolved.
The PURGE IPSEC command caused a fatal error. This issue has been
resolved.
PCR: 02272
Module: IPG, PIM, SWI
Network affecting: No
PCR: 02274
Module: TPAD
Network affecting: No
PCR: 02276
Module: FIREWALL
Network affecting: No
PCR: 02277
Module: DVMRP
Network affecting: No
PCR: 02280
Module: TELNET, TTY
Network affecting: No
PCR: 02291
Module: DHCP
Network affecting: No
PCR: 02292
Module: IPSEC
Network affecting: No
PCR: 02294
Module: IKMP
Network affecting: No
PCR: 02298
Module: IPSEC
Network affecting: No