Allice Messtechnik R&S ZND, User Manual, Page: 919 / 1252

Command reference
R&S
®
ZND
919 User Manual 1173.9557.02 ─ 61
Use
[SENSe<Ch>:]CDLL:PERManent:ADDitional
to further specify the task.
Suffix:
<Ch>
.
Channel number
Parameters:
<Task> Name of the task to be run permanently.
Parameters for setting and query:
<DllName> Name of a loaded DLL (see
[SENSe:]CDLL:LIST?
)
Lowercase string, without
dll
extension
Manual operation: See "Task Type" on page 262
[SENSe:]CDLL:REMove <DllName>
Tells the analyzer firmware to remove a custom (external) DLL that was previously
added using
[SENSe:]CDLL:ADD
.
Note that adding/removing custom DLLs is only possible if the firmware is run as
administrator.
Setting parameters:
<DllName> Name of a loaded DLL (see
[SENSe:]CDLL:LIST?
)
Lowercase string, without
dll
extension
Usage: Setting only
Manual operation: See "Add / Remove" on page 263
[SENSe<Ch>:]CDLL[:STATe] <DllName>, <Boolean>
[SENSe<Ch>:]CDLL[:STATe]? <DllName>
Defines the state of (external) DLL
<DllName>.dll
in channel <Ch>.
An active DLL can provide traces or operate in permanent mode (see
[SENSe<Ch>:
]CDLL:PERManent[:STATe]
).
Suffix:
<Ch>
.
Channel number
Parameters:
<Boolean> ON (1)
DLL is active
OFF (0)
DLL is inactive
Parameters for setting and query:
<DllName> Name of a loaded DLL (see
[SENSe:]CDLL:LIST?
)
Lowercase string, without
dll
extension
Manual operation: See "Active" on page 262
SCPI command reference
www.allice.de Allice Messtechnik GmbH