Allice Messtechnik R&S ZND, User Manual, Page: 357 / 1252

GUI reference
R&S
®
ZND
357 User Manual 1173.9557.02 ─ 61
5.8 Stimulus softtool
On the "Stimulus" softtool, you can access to the stimulus parameters of the active
channel. If the active trace is represented in
Time Domain , it also allows you to config-
ure the "observation interval".
Access: STIMULUS – [START] | [STOP] | [CENTER] | [SPAN] hardkey
●
While in Cartesian diagrams the x-axis represents the stimulus values, in polar and
Smith diagrams this direct relation is lost. In any case, a marker can be used to dis-
play the stimulus value of a given trace point.
For "Time Domain" traces, points in the "observation interval" are interpreted as
stimulus values.
●
All stimulus settings except the "Time Domain X-Axis" settings are channel set-
tings. "Time Domain X-Axis" applies to the active (time domain) trace only.
Background information
Refer to the following sections:
●
Chapter 4.1.3, "Traces, channels and diagrams" , on page 75
●
Chapter 3.3.6.2, "Setting the sweep range" , on page 61
●
Chapter 3.3.6.6, "Set by marker" , on page 63
5.8.1 Stimulus tab
Defines the sweep range in the current channel, depending on the sweep type.
Related Settings
Refer to the following sections:
●
Chapter 4.1.4.4, "Stimulus and sweep types" , on page 81
●
Chapter 5.10.2, "Sweep Type tab" , on page 367
Stimulus softtool
www.allice.de Allice Messtechnik GmbH