Allice Messtechnik R&S ZND, User Manual, Page: 250 / 1252

GUI reference
R&S
®
ZND
250 User Manual 1173.9557.02 ─ 61
P = V
2
/ Re(Z
0
).
Z
0
denotes the reference impedance of the source port (for wave quantities a
n
) or of
the receive port (for wave quantities b
n
). The reference impedances are defined in the
"Balanced Ports" dialog; see Chapter 5.2.1.3, "Balanced Ports dialog" , on page 239.
Remote command:
CALCulate<Chn>:FORMat:WQUType
Detector
Selects the algorithm that is used to calculate the results points from the raw measure-
ment data.
For details refer to Chapter 4.3.5.3, "Detector settings" , on page 119.
Remote command:
CALCulate<Ch>:PARameter:MEASure
CALCulate<Ch>:PARameter:SDEFine
[SENSe<Ch>:]SWEep:DETector:TIME
5.2.4 Z←Sij tab
Selects converted impedances as measured quantities. The impedances are calcula-
ted from the measured S-parameters.
Background information
Refer to the following sections:
●
Chapter 4.3.3, "Impedance parameters" , on page 112
●
Chapter 4.3.3.1, "Converted impedances" , on page 112
left = bidirectional R&S ZND
right = unidirectional R&S ZND
Meas softtool
www.allice.de Allice Messtechnik GmbH