Adjustments
Leveling Legs
1. Place a level on the cabinet top and check if the washer is lev-
el from side to side and front to back.
2. If washer is not level, tilt washer back to access the front lev-
eling legs. Loosen the locknuts and adjust legs by screwing
into or out of washer base.
3. Once adjusted, tilt the washer forward on front legs and lower
back down into position to set the rear self-leveling legs.
4. Washer must not rock. When washer is level and does not
rock, tighten locknuts securely against bottom of washer base.
If these locknuts are not tight, washer will not remain station-
ary during operation.
Improper installation or flexing of weak floor will cause exces-
sive vibration.
Do not slide washer across floor once the leveling legs have been
extended, as legs and base could become damaged.
NOTE: For areas with uneven floors, a No. 566P3
Adjustable Rear Leg Extension Kit is available as
optional equipment at extra cost.
TLW2286N_SVG
5
4
3
2
1
1.
Level
2.
Locknut
3.
Leveling Leg
4.
Rubber Foot
5.
Washer Base
Figure 5
Belt
No belt adjustment is required.
Drive Bell Torque
When replacing or reinstalling the drive bell, torque bolts to these
specifications.
Location
Minimum
Maximum
Drive Bell to Wash-
tub and Hub
100 inch-pounds
[11.3 Nm]
140 inch-pounds
[15.8 Nm]
Drive Bell to Top of
Drive Shaft
60 inch-pounds
[6.78 Nm]
100 inch-pounds
[11.3 Nm]
Table 11
Adjustments
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
33
Part No. 204666ENR1
Summary of Contents for ZWN43RSN115CW01
Page 2: ......
