505039
43
Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the dryer(s) before servicing.
• Close gas shut-off valve to gas dryer(s) before servicing.
• Never start the dryer(s) with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the dryer is properly grounded.
W001R1
WARNING
29. INNER AND OUTER DOOR PANELS AND
DOOR PULL
a. Remove four screws holding door assembly to
b. Remove remaining screws around the door
perimeter and separate panels. See Figure 32.
c. Remove wedge (located behind door pull) by
carefully prying up on center of wedge. See
Figure 32.
d. Remove door pull. See Figure 32.
30. DOOR STRIKE
a. Open loading door.
b. Remove screw holding door strike and bracket
to loading door and remove strike and bracket.
NOTE: You may have to loosen the two screws on
end of door to allow for strike and bracket removal.
Figure 32
D343PE3B
DOOR SEAL
DOOR
STRIKE
DOOR HINGE
DOOR STRIKE
BRACKET
SCREWS
INNER DOOR PANEL
AND SEAL ASSEMBLY
SCREW
DOOR
PULL
WEDGE
SCREW
FRONT
PANEL
OUTER DOOR
PANEL
