505039
17
Section 3 Troubleshooting
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the dryer(s) before servicing.
• Close gas shut-off valve to gas dryer(s) before servicing.
• Never start the dryer(s) with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the dryer is properly grounded.
W001R1
WARNING
14. IGNITION CONTROL FLASHES (continued)
FLASH CODE
POSSIBLE CAUSE
TO CORRECT
Five Flashes
Loose or disconnected wiring.
• Check all wiring leading to, or coming from,
the control module for secure connections.
Inoperative gas valve.
• Check gas valve and replace if necessary.
Inoperative flame sensor.
• Replace flame sensor/igniter.
Six Flashes
Loose or disconnected wiring.
• Check all wiring leading to, or coming from,
the control module for secure connections.
Incorrect wiring.
• Check wiring diagram and make sure dryer is
wired correctly.
Incorrect polarity.
• Contact a professional electrician to check the
polarity, and correct any problems.
Seven Flashes
Loose or disconnected wiring.
• Check all wiring leading to, or coming from,
the control module for secure connections.
Flame sensor and/or appliance not
properly grounded.
• Check grounding from control to base, and
from lead in cord to dryer.
Rapid Flashing
Incorrect frequency.
• Contact a professional electrician to check the
frequency, and correct any problems. Power
supply must be 50 – 60 Hz. 2-wire, plus
grounding (earth) wire.
Figure 1
WR
WHITE - ROGERS DIV.
EMERSON ELECTRIC CO.
DISCONNECT POWER
BEFORE SERVICING
DISCONNECT POWER
BEFORE SERVICING
DISCONNECT POWER
BEFORE SERVICING
DISCONNECT POWER
BEFORE SERVICING
DISCONNECT POWER
BEFORE SERVICING
DISCONNECT POWER
BEFORE SERVICING
DISCONNECT POWER
BEFORE SERVICING
DISCONNECT POWER BEFORE
SERVICINGGDGHDHJD DHJD DHD HD
HD HD HDGFJGFKGK GFJHGJ FHFH
F KJFJF KH GJHJF JDAPALS DK KF
DISCONNECT POWER BEFORE
SERVICING SERVICEING OK
IMPORTANT
DIAGNOSTIC INDICATOR
MODEL 50A72-203.
WARNING
WR
CONTROL
RED
LIGHT
D194SE3B
