Alliance Laundry Systems LWS02A series, Operating Instructions Manual

Page: 3 / 8

3
39090
D305IE1A
W318IE0C
W383IE0A
W395IE0B
p "’^ dp›^F’
IMPORTANT: Before using your new washer,
make sure the washer cord is plugged into a 120
Volt electrical outlet that has the proper
grounding and polarity. Make sure the washer
hoses are connected to the hot and cold water
faucets, and that the faucets are turned on. Be
sure the drain hose is not kinked and is inserted
into a drain. See the INSTALLATION
INSTRUCTIONS for details of proper washer
installation.
IMPORTANT: Prior to first wash, use an all
purpose cleaner or a detergent and water
solution and a damp cloth to remove shipping
dust from inside of washtub.
1. Get the clothes ready for
washing. Empty pockets and
cuffs. Sort items into
separate loads. Pretreat stains
and heavily soiled areas.
2. Measure and add detergent to
the washtub.
3. Add clothes loosely into the
washtub.
4. Close the loading
door. The washer will not
agitate or spin with the
loading door open.
5. Set WASH/RINSE temperatures.
NOTE: The washer will
provide a cold rinse in all
TEMPERATURE settings.
Cold rinses will save you
money and energy and will
help reduce wrinkling in
permanent press and
synthetics.
The Energy Saver settings, marked with a
dot (•), show which temperature settings will
use the least energy.
6. Set LOAD SIZE
(WATER LEVEL)
control. Use RESET if
agitation has started and
more water is needed.
IMPORTANT: Holding the LOAD SIZE
(WATER LEVEL) control in the RESET
position can cause flooding of the washer.
7. Select the cycle according to the type of fabric
being washed. Push the timer knob in and turn
clockwise to the desired cycle and wash time.
8. Pull the timer knob out to start the water fill.
Agitation will begin when the water reaches the
level you selected.
The washer will stop (pause) shortly before the
wash and rinse spins. Do not turn the timer
through these pauses. They are part of the cycle.
ahF
Although the washer cycles are automatic, the timer
may be reset to lengthen, shorten or repeat a portion
of a cycle.
To set or reset the timer, push timer knob in to stop
the washer. Hold timer knob in firmly while turning
it clockwise to the setting desired. Pull timer knob
out to start the washer.
p"camV
Set the timer knob in the center of the word
“RINSE” (this prevents the washer from spinning
without first filling with water). Place the soaking
product and clothes load in the washtub. Pull timer
knob to start washer fill. After fill is completed and
agitation has started, push the timer knob in. This
will stop the washer. When the clothes have soaked
the desired length of time, TURN THE TIMER
KNOB TO THE END OF THE RINSE SETTING,
then pull the timer knob out to start the spin.
CAUTION: Failure to turn the timer knob to the
spin cycle and completely draining the washtub
after soaking will result in the washer
overflowing and causing property damage.
To reduce the risk of serious injury, do
not by-pass the loading door switch by
permitting the washer to agitate or spin
with the loading door open.
W019E
WARNING